Before & After Photos

Gerald H. recently moved into his home in last year. He was aware that there could be possible problems with the foundation. He started to notice that the hallway floor from the garage was starting to become uneven the door was not longer closing properly. Ready to learn about foundation repair solutions, he gave us a call.

System Design Specialist Elliot Moles went out to Gerald’s home. He was able to see that the floors were uneven, and the door was sticking and came up with the solution of installing Push Piers. We installed three Push Piers to lift the hallway and bring the floors back to level. Gerald was extremely thrilled to have the floors level and didn’t realize how much of an impact this would have on his home.

Our customer is a firm believer in leaving a home in a better place than what she found it in. She takes a lot of pride in her home! We noticed that in the basement the main beam was sagging aggressively towards the middle of the home. The home is pre-1920 and needed additional support throughout the whole main beam. In order to fix the problem, we presented the SmartJack XT to our customer. We explained to her that this is a long-term solution that will create instant results for her home.

Thrasher Foundation Repair recently installed SmartJack manufactured here in the USA to stabilize a sagging floor. If you are noticing sagging or bouncy floors call today for a free estimate.  

This homeowner had a block foundation wall that was bowing in and he was concerned that the wall was going  to collapse. After getting a few estimates, he knew that he needed our help and expertise to fix his bowing wall.

We sent System Design Specialist Mike Portel to inspect the bowing wall and determine what was causing this. Mike found that the soil on the outside of the block wall foundation, causing the wall foundation to fall inwards. He also noticed that there were cracks in the wall that appeared to have grown over time. Mike and the team installed PowerBraces so that the homeowner could move his foundation walls back to their position over time.

The homeowner was very happy with the quality of work and with the professionalism of the group. Check out his new PowerBrace System. 

When our team walked into this home through the front door, there was an obvious bounce in the floor. Upon investigation, the floor was being held up by telephone poles that were cut to fit but they were not strong enough to hold keep holding the home up. Also, the floor was not level. The homeowner was concerned about the bounce and the ability of the floor to withstand weight since it was not supported very well. We fixed the problem by adding SmartJacks to the crawlspace to hold up the floor. There are 2 supplemental beams that run the length of the house. We added 5 Smartjacks to the front of the home and 5 more SmartJacks to the back of the home. We also added a supplemental beam in-between the existing cinderblock supports to finish supporting the house/floor from sagging and bouncing.