Before & After Photos

This homeowner wanted to repair the downstairs bedroom so she could host her grandkids. In this bedroom, the concrete floor was sinking about 3" in the center of the room. We were able to lift and level the floor using PolyLevel, a polyurethane foam, so now it no longer feels like the room is sinking.

This Overland Park foundation repair job included the installation of foundation piers, as well as epoxy crack repair.

A qualified foundation repair contractor or structural engineer should be consulted to determine if a crack in your foundation is merely cosmetic or of a more serious nature.

The goals for this residence were to achieve a minimal lift, to stabilize the structure on the east and south foundation walls, and to close the large crack on a corner. Thrasher and the consulting geotechnical engineer determined that resistance piers would be ideal to provide supplemental support in this situation.

The photos below show the large diagonal crack that had appeared on the corner of the foundation wall. The crack gaped open a half-inch or more.

Thirteen resistance piers were installed along the interior of the east and south foundation walls. Twelve linear feet of urethane injection was used to fill and seal the large crack after the piers were installed. The piers were hydraulically pushed into the soil beneath the home until a predetermined load-bearing stratus was reached.

This customer was worried that her home was a tripping hazard due to concrete settlement. The biggest area of concern was the front porch. When we inspected, we found that the two slabs on their front walkway had settled at a couple different joints. This happened due to the soil underneath the slab drying out and shrinking, then eroding away when it would rain. 

To fix, we injected a poly foam to lift the slab and eliminate the tripping hazard. We then sealed the joints with a joint sealer to make sure moisture doesn't find its way under the slab again. 

Every time this homeowner hears a new creak in his house he fears the structure is about to fall down. He even set up columns next to the wall to help hold up that end of the house in case something did happen. To relieve his fears he called us to take a look and repair his foundation. The fall was severely bowed, so we installed EverBrace, a steel panel system that strengthens the existing structure. 

A homeowner in Stilwell, KS wanted her driveway to look new again. After using PolyLevel foam to lift the sinking concrete and our NexusPro joint sealant to protect the joints, this driveway got the look she was looking for!